Select Git revision
openocd.texi
-
Marc Schink authored
Make 'offset' and 'length' parameters optional, if both are omitted simply read the whole flash bank. Additionally, check if the 'offset' and 'length' arguments are out of bounds of the flash bank. Change-Id: Ib9c1b0538a2c78ebcf702e2da11468dff407f8ff Signed-off-by:
Marc Schink <openocd-dev@marcschink.de> Reviewed-on: http://openocd.zylin.com/3862 Tested-by: jenkins Reviewed-by:
Tomas Vanek <vanekt@fbl.cz>
Marc Schink authoredMake 'offset' and 'length' parameters optional, if both are omitted simply read the whole flash bank. Additionally, check if the 'offset' and 'length' arguments are out of bounds of the flash bank. Change-Id: Ib9c1b0538a2c78ebcf702e2da11468dff407f8ff Signed-off-by:
README.md 1.02 KiB
microcutting
Comparison of micro-waterjet, laser, EDM, NC, ... cutting
micro-waterjet
[MicroMAX at OMAX Demo Lab - https://www.omax.com/omax-waterjet/micromax]
solid-state laser micromachining
ultrafast laser micromachining
EDM
NC
Fablight fiber laser
Machining time: ~5 min
Cost of machine: sheet only machine with the 3000 laser is around $80,000, and the tube & sheet is around $90,000
Machine settings:
Sample photos:
After burr removal
The brown seen on the edges of the piece are burn marks where the machine cut.